-
MilesCanton replied to the topic Tilt Connector in the forum T-SLOT QUESTIONS & ANSWERS 2 years, 2 months ago
Mainly used for corners where you don’t want the connected the pieces to rotate.
-
MilesCanton replied to the topic Advantage of T Slot Aluminum in the forum T-SLOT QUESTIONS & ANSWERS 2 years, 2 months ago
It’s more flexible, lower maintenance fees and cheaper in the long run.
-
MilesCanton replied to the topic Corrosion in the forum T-SLOT QUESTIONS & ANSWERS 2 years, 2 months ago
Aluminium is an alloy and as such is more resistant to rust/corrosion
-
MilesCanton replied to the topic DIY KIT in the forum T-SLOT QUESTIONS & ANSWERS 2 years, 2 months ago
I also recommend MiniTec, they can even spin up something custom for you
-
MilesCanton replied to the topic Fasteners and connectors in the forum T-SLOT QUESTIONS & ANSWERS 2 years, 2 months ago
I usually use a combination of angle connectors and milling connectors for most projects. Although of course using bolt connectors where needed.
-
MilesCanton replied to the topic Money saver in the long run. in the forum T-SLOT QUESTIONS & ANSWERS 2 years, 2 months ago
With the low maintenance fees, if you’re using it for a long time you save a lot in the long run.
-
MilesCanton replied to the topic Rearrangement in the forum T-SLOT QUESTIONS & ANSWERS 2 years, 2 months ago
It is possible depending on how you assembled it.
-
MilesCanton replied to the topic Durability in the forum T-SLOT QUESTIONS & ANSWERS 2 years, 2 months ago
That’s honestly one of the best things about it.
-
MilesCanton replied to the topic Basic parameters in the forum T-SLOT QUESTIONS & ANSWERS 2 years, 2 months ago
Would also like to note that you should use high-strength extrusion systems for more demanding applications
-
MilesCanton replied to the topic Versatility in the forum T-SLOT QUESTIONS & ANSWERS 2 years, 2 months ago
They are quite flexible and modular.
-
MilesCanton replied to the topic T-Slot source? in the forum T-SLOT QUESTIONS & ANSWERS 2 years, 2 months ago
Have you tried reaching out to MiniTec?
-
MilesCanton replied to the topic Tools for DIY in the forum T-SLOT QUESTIONS & ANSWERS 2 years, 2 months ago
Recommend ordering them pre-drilled as I find it quite a hassle otherwise. And then a simple hex wrench with a T handle should suffice.
-
MilesCanton replied to the topic T-Slot framing for Aquarium Stand in the forum T-SLOT QUESTIONS & ANSWERS 2 years, 2 months ago
I’d be a bit weary of using a 1″ on a 15gal tank to be honest, much better if you can go 2″
-
MilesCanton changed their profile picture 2 years, 2 months ago